您好,欢迎访问易彤破壁机售后维修中心!

优秀品牌

百年故事

质量保障

原故障报修90天

使用年限

高出平均寿命30%

全国咨询热线

(010)-5367-2025

易彤破壁机维修_易彤料理机售后服务(010)-5367-2025
您的位置:主页 > 新闻动态 >

新闻动态

联系我们

地址:北京市门头沟区滨河南路3号院1号楼

咨询热线:

(010)-5367-2025

15726676726

易彤料理机修理障维修方法!

发布时间:2023-03-02 00:07人气:
易彤料理机修理障维修方法!

  Constant temperature faucet is usually used in the kitchen and bathroom,Not only used for washing vegetables and prevent frozen and rupture,It is also possible to install whether the constant temperature faucet does not produce hot water when installed in the bathroom for washing clothes.。Water water does not produce after the constant temperature faucet is installed,Is a normal phenomenon,Don't say anything, look at it., lack of experience,May be a cold water pipe installation error,Need to correct it again,other problems,Please refer to the description。

  

  1。 Constant temperature faucet common fault

  1。 Waste water is hot and cold:

  (1)This happens,It is necessary to check that water is continuous or discontinuous.,If it is continuous, it is necessary to lower the pressure of cold water or hot water.,High pressure。

  (2)If it is intermittent,Test if the hot water temperature is too high,If the hot water temperature is too high,Adjust the handle of the constant temperature spool,Turn your handle to a low temperature,Adjusted to34-36℃It is okay between。No longer there is such problems; If still unable to solve,Need to replace the spool,This is the worst plan。

  2。 There is no hot water:

  (1)Turn the water temperature to38℃Above,The problem with no hot water should be that the water does not enter the valve body.,Inlet or clogging or pipelines in the pipe; This is better cleaning cleaning gasket filter gasket, Or discharge cold water from the hot water pipe,Repeated check。

  (2)Water temperature38℃the above;It is necessary to check whether the hot water temperature reaches the hot water temperature.55℃,Look at whether the hot water pressure is low,Usually appeared in the bungalow and loft users; You can improve hot water temperature,Adjusting cold water 易彤破壁机哪里可以维修 pressure。

  (3)Only a water,The main problem is the reverse connection of hot and cold water.。Need to replace the water,Failure can be recovered very well。

  3。 Water temperature is unstable

  Gas water heater does not fall, Stop when you click。This happens,Let the water are cold for a while; The flow and temperature of the water heater may be insufficient; Gas water heaters need to be adjusted to large flow。Fire。

  4。 Electric water outlet temperature with constant temperature tire:

  When the electric water heater is factory,Generally set the temperature50℃about,When the hot water of the heap is insufficient; Need to reset the temperature of the electric water heater,It is recommended to set it60°Cabout。

  5, Cold water flows to hot water or hot water to cold water(Water):

  Check whether the check valve of cold water or hot water is supported or blocked by foreign matter or blocked,Use a screwdriver to gently push it,Then put it in the water.; If the problem is still unable to solve,Replace the one-way valve。

  6。 Drops of any interface of the faucet:

  In the interface location,Use the tool slightly tighten or wrap the raw material around the thread position,Then close the faucet,See if there is a water droplet usually,Can be repaired。

  2。 Check if the constant temperature faucet does not produce hot water after installation

  1。 To ensure hot water and cold water,Water supply and left cold hot water supply cannot be exchanged。Three times must be performed before and after this,Otherwise it will affect the use effect。

  2。 When the cold water is needed or suddenly cut off the cold water,The faucet will automatically close,Armive function; if not,Contact the captain to handle in time。

  3。 Make sure the check valve in the installation joint is unimpeded,Remove the connector,You can use the mouth to blow the test in a quarter threaded end.; If ventilation is no problem,Neck which check valve needs to be replaced?

  Water water does not produce after the constant temperature faucet is installed,Not a fault should be a mistake,If check in advance,There will be no such problem,This shows that the idea is not complete enough,Please pay attention later。After installation, the constant temperature faucet does not produce hot water,I also talked about the problems that may arise in use.,Understand,Can be sent。

上文就是为大家讲的易彤料理机修理障维修方法!了。

本文地址:http://www.josia.cn/a/xinwendongtai/1526.html

推荐资讯