Back cover of the watch For the internal parts of the watch,under normal circumstances, We recommend that you don't open it without authorization.。But if we need to replace the battery or clean the battery, How do we open it??So how to properly install the back cover?Please refer to the editor's introduction。
Remove the back cover
After opening the rear cover,We recommend using a dedicated meter to open the tool,Spiral waterproof watch。The upper casing and back cover of the case have threads,Relying on thread function, The upper shell and the rear cover are tightened together。Roll the watch glass with tools,Strict。Place the waterproof gasket in the handle,And screw the back cover and upper shell together。Therefore, you can play a certain waterproof effect.。
There are many ways to turn on and close the back cover of the watch。But the screw rear cover and the pressure rear cover are most。The second is to use some screws to tighten the back cover。Press the back cover of the watch,As long as we can open it through some basic tools,Just just press it when you recover,Remove,This is 易彤破壁机全国维修点 the easiest。
If there is condition, it should also use professional table to open tools as much as possible.,There is a starter similar to the old tiger pliers,Simply put your watch bracket on your wrist,The knife of the labelWatch back coverOpening,As long as you have the power You can easily open the back cover of the watch。
The back cover of the pressed water-proof watches is very special。The upper case of its housing is pressed on the bottom。There is a high wall around,The movement is mounted in the back cover,Watch glass is installed on the wall of the back cover,The watch glass and back cover are tightly wrapped after the upper shell is pressed.,Thus a sealing waterproof effect。
Remove and installWatch back cover
Matching tables more prone to problems,I often encounter a watch that cannot be fastened.。After all attempts, They all ended with failure。The correct installation method is as follows!
Place the back cover of the watch on the hard desktop。 Use a soft cloth on the front glass of the watch,Press evenly with your palms.。Adjust the position of the cover,If the gap is in which direction does not click the wrong location。 Turn off the front face of the cover watch。 Balance the gap on each side of the cover(Keep all directions basically)。such,The bottom cover of the watch has been successfully put back into place。